Configure IP Address and DNS from Command Line. Would you like to configure the IP address and DNS settings of your Windows PC just using the command prompt?
This document outlines the basic steps required to install and configure Cisco IP Communicator with Cisco CallManager 4.x through manual setup. For autoregistration.
The first thing you need to identify is the name of the network interface you want to modify. You will want to leave this as 1 for almost all cases. For the primary DNS server run: netsh interface ip set dns name=.
- Select Use the following IP address and Use the following DNS server addresses to change your computer's IP address and/or DNS server addresses.
- How to Configure DHCP in Your PC. Dynamic Host Configuration Protocol (DHCP) is the configuration of your Internet Protocol (IP) address, subnet mask, DNS servers.
- The default Max Transfer Unit (MTU) size for ethernet is 1500 bytes, if using a network with a different MTU size, then one should make sure to configure MTU in.
- You can perform a variety of tasks using the Netsh command-line utility, including configuring the IP addresses of network adapters in Windows.
- How do I find my IP address? Click Start and select Run. Type command into the open window. Type ipconfig at the command prompt.
- Updated: October 5, 2009. Applies To: Windows 7, Windows Server 2008, Windows Server 2008 R2, Windows Vista.
- Would you like to configure the IP address and DNS settings of your Windows PC just using the command prompt? Rather than click through the user interface, these.